StrongArm Brand Products rust remover and paint over undercoating.

Home > USAGES > Paint Over USA Fluid

Paint right over USA Fluid Unlimited StrongArm
Products on Rust or Any metal or surface.

It's a Simple 1, 2, 3 Then Paint it Process as shown right here...

1) We Take the hunk of rusty iron and Apply USA Fluid the Unlimited StrongArm.
It can be brushed over the surface from the nipple dispenser bottle and a small 1 or 2 inch paint brush. 100% of the USA Fluid goes on the surface with no loss.

The other products have a hair spray nozzles that make a mist which loses nearly all of it into the air as pollution.

2) Brush the surface of the metal with a wire brush for up to a half minute.

3) Wipe the surface with an old cotton cloth, towel or rag.
The surface is now undercoated and READY FOR PAINT with a weatherproof bulletproofing that will remain Under the Paint !! You can't do this with anything else !!.

Remember: DO NOT remove the USA Fluid The Unlimited StrongArm with any paint removers thinners and cleaners. That is NOT necessary and a waste of material and expense.

Lightly Apply Enamel or Lacquer paint by spray or brush and let it stand. Allow time for drying. Then put the piece out in the sun or warm area to cure paint. With the USA Fluid the paint will have superior adhesion and carry the paint into the surface deep below the paint. The painted surface will not rust anymore, even if the paint is scratched away in use..

It's That simple.

No Gimmicks
No Fluff
No Hype
Just the Facts..

Order Here 24/7 at the
online Web Store

USA Fluid Online Store